How To Change Headlight Bulb In Your Car

how to change headlight bulbThe headlight is one of the most important parts of your vehicles (Car, Bike and heavy vehicles bus and Trucks) if your car headlights are off at night, police will impose a penalty to you besides you can get an accident.so that you should take care of your vehicle’s headlight. Before going outside you must check your car headlight bulb whether it’s OK or not. It’s an electric item and can be burnt or stop at any time. The most old vehicle having these problems more, that’s why you should more careful about your old car, For new vehicles, it’s happening less but could be happened in any time due to lack of alertness.

Sometimes we see headlight not glowing, most the people think headlight bulb cutoff or burnt, but after checking we see headlight bulb is OK and headlight fuse is burnt, it’s a good sign that your fuse cutoff, otherwise your total wiring can be burnt out. So always use a proper fuse in your car which recommended by the manufacturer.

If you know How To Change Headlight Bulb then you can do it or you should go to good Auto Electrician, also keep in mind always use Quality Headlight Bulbs as per recommendations of the vehicle manufacturer. If you read our articles we think you can replace your car headlights Bulb by yourself.

Also, You Can Read

Required equipment and tools:

  1. Headlight Bulb
  2. Some wire
  3. Scotch Tape
  4. Screwdriver
  5. Pliers
  6. Hand Gloves
  7. Headlight Sealant

Step 1

From the beginning you must read the guidelines manual of the vehicle manufacturer, you don’t need much more tools for replacing the headlight bulbs. With one screwdriver you can replace your headlight bulb. Make sure your car ignition key off then you need to disconnect the battery negative terminal for more safety Open the front hood of the car, locate the backside of the headlight, and find out the bulb holder it will have 2 or 3 wire coupling with a socket.

Step 2

You should carefully remove the wiring’s, plastic catch, metal clips or some necessary wire clips

Step 3

With the wiring out of the way, you must be able to pull the bulb out by holding onto the bottom (the part that the plug was in). In some cases, you will have to be compelled to rotate the bulb slightly for it to unharness or gently wiggle it to loosen it.

Step 4

Before you’re taking the new bulb out of the packaging, grab a tissue or a clean rag. If the oils on your skin get on the glass bulb, it will blow out. If you need to touch the glass, do it with the tissue. Holding the bulb’s plug finish, stick it into the rear of the headlamp. Take care visually to make sure that it’s all the way in. you’ll tell as a result of it’ll be lined up equally and none of the bulb’s rubber seal is going to be showing.

Step 5

Plug the wiring back in and rescuer the bulb. Testing your new headlamp bulb is as easy as turning on your car’s headlights. If one or both of the bulbs do not turn on, check the wiring to make sure you are securely connected them. Have a bad tail light or turn indicator bulb? You can replace those bulbs, too.

Here we point out another important tip for long life your car headlight also Dust-free you can use best headlight sealant, headlight sealant Keeps your Lights lens clear and bright. it will save your money and valuable time also.

You Car Watch this Video for More Learning 

Our More Articles :

Recent Posts